应用:
物联网应用,如:
- 医疗和保健
- 多参数患者监护仪
- 心电图(ECG)
- 电子医院病床和床控
- 远程医疗系统
Downlode
BDE-WF3235SFA_Datasheet_EN_V2.0.pdf
- 暖通空调系统和恒温器
- 视频监控、视频门铃、低功耗摄像头
- 建筑安全系统和电子锁
- 电器
- 资产跟踪
- 工厂自动化
- 网基础设施
下载
WF3235SFA_Datasheet_EN_V1.0.pdf
碧德(BDE)是美国德州仪器(TI)第三方合作伙伴
BDE-WF3235SFA(U)是一款基于CC3235S(或CC3235SF) SoC的802.11a/b/g/n, 2.4GHz和5GHz双频,IPv4和IPv6, 256KB RAM(或1MB可执行flash/256KB RAM)的低能量MCU模块。该模块提供了一个独特的组合,更低的功率,集成所有外部组件,包括双频芯片天线,成本非常低廉。
BDE-WFM20B模块为物联网而创建,是一个无线模块,集成了两个物理上分离的片上mcu,一个CM4应用处理器和一个网络处理器。BDE-WFM20B引入了新的功能,进一步简化了事物到互联网的连接。BDE-WFM20B的主要功能包括:
•802.11 a/b/g/n:支持2.4 GHz和5ghz
•2.4 GHz与蓝牙®低能量无线电共存
•集成双频芯片天线或外置天线UFL连接器
•更多的并发安全套接字,多达16个
•具有生成证书签名请求(CSR)能力的唯一设备标识符
•在线证书状态协议(OCSP)
•Wi-Fi Alliance®通过物联网低功耗能力认证
•卸载模板包的无主机模式
•改进的快速扫描。
•应用处理器- Arm®Cortex®- m4 MCU,配有用户专用256KB RAM和可选1MB
可执行的闪光。
•网络处理器,运行所有Wi-Fi和互联网逻辑层。
这个基于rom的子系统完全
卸载主机MCU,并包括一个802.11 a/b/g/n双频2.4 ghz和5 ghz无线电、基带和
MAC具有强大的硬件加密引擎。
•32Mbit SPI串行flash。
Key Features
- 802.11a/b/g/n: 2.4 GHz and 5 GHz
- FIPS 140-2 Level 1 validated IC inside
- Multilayered security features help developers protect identities, data, and software IP
- Low-power modes for battery-powered applications
- Coexistence with 2.4-GHz radios
- Industrial temperature: –40°C to +85°C
- Antenna: Integrated Dual-band chip antenna or UFL connector
- 1.27-mm pitch QFM package for easy assembly and low-cost PCB design
- Transferrable Wi-Fi Alliance® certification
- Application microcontroller subsystem:
- Arm® Cortex®-M4 core at 80 MHz
- User-dedicated memory:
- 256KB of RAM
- 1MB of executable flash (BDE-WFM20BSF)
- Rich set of peripherals and timers:
- McASP supports two I2S channels
- SD, SPI, I2C, UART
- 8-bit synchronous imager interface
- 4-channel 12-bit ADCs
- 4 general-purpose timers (GPT) with 16-bit PWM mode
- Watchdog timer
- Up to 27 GPIO pins
- Debug interfaces: JTAG, cJTAG, SWD
- Wi-Fi network processor subsystem:
- Wi-Fi® core:
- 802.11 a/b/g/n 2.4 GHz and 5 GHz
- Modes:
- Access point (AP)
- Station (STA)
- Wi-Fi Direct® (only supported on 2.4GHz)
- Security:
- WEP
- WPA™/ WPA2™ PSK
- WPA2 Enterprise
- WPA3™ Personal
- Internet and application protocols:
- HTTPs server, mDNS, DNS-SD, DHCP
- IPv4 and IPv6 TCP/IP stack
- 16 BSD sockets (fully secured TLS v1.2 and SSL 3.0)
- Built-in power management subsystem:
- Configurable low-power profiles (always on, intermittently connected, tag)
- Advanced low-power modes
- Integrated DC/DC regulators
- Multilayered security features:
- Separate execution environments
- Networking security
- Device identity and key
- Hardware accelerator cryptographic engines (AES, DES, SHA/MD5, CRC)
- File system security (encryption, authentication, access control)
- Initial secure programming
- Software tamper detection
- Secure boot
- Certificate signing request (CSR)
- Unique per device key pair
- Application throughput
- UDP: 16 Mbps
- TCP: 13 Mbps
- Power-Management Subsystem:
- Integrated DC/DC converters support a wide range of supply voltage:
- Single wide-voltage supply
VBAT: 2.3 V to 3.6 V
- Advanced low-power modes:
- Shutdown: 1 μA, Hibernate: 5.5 μA
- Low-power deep sleep (LPDS):120 μA
- Idle connected (MCU in LPDS):710 μA
- RX traffic (MCU active): 59 mA
- TX traffic (MCU active): 223 mA
- Wi-Fi TX power
- 2.4 GHz: 16 dBm at 1 DSSS
- 5 GHz: 15.1 dBm at 6 OFDM
- Wi-Fi RX sensitivity
- 2.4 GHz: –94.5 dBm at 1 DSSS
- 5 GHz: –89 dBm at 6 OFDM
- Additional integrated components
- 40.0-MHz crystal
- 32.768-kHz crystal (RTC)
- 32Mbit SPI serial flash
- RF filters, diplexer and passive components
- Footprint-compatible QFM package
- 1.27-mm pitch, 63-pin, 23mm × 20.5mm
- Module supports the TI SimpleLink Developer's Ecosystem
-Certifications
- FCC ID: 2ABRU-WFM20B
- IC: 25657-WFM20B
- CE-RED