BDE-MP2651R3A(Multi-Protocol Based on CC2651R3)-BDE Technology Inc.

Location:Home - Products

Products

Bluetooth/WiFi Combo

Bluetooth Dual-Mode

Multi-Protocol - BDE-MP2651R3A(Multi-Protocol Based on CC2651R3)

BDE-MP2651R3A(Multi-Protocol Based on CC2651R3)
The BDE-MP2651R3A is a single-protocol 2.4-GHz wireless module supporting Zigbee®, Bluetooth® 5.0 Low Energy, IEEE 802.15.4g, TI 15.4-Stack (2.4 GHz). The module is based on an Arm® Cortex® M4 main processor and optimized for low-power wireless communication and advanced sensing in grid infrastructure, building automation, retail automation, personal electronics and medical applications.

BDE-MP2651R3A has a software defined radio powered by an Arm® Cortex® M0, which allows support for multiple physical layers and RF standards. The device supports operation in the 2400 to 2480-MHz frequency band. The module supports +5 dBm TX at 9.5 mA in the 2.4-GHz band. It has a receive sensitivity of -103 dBm for 125-kbps Bluetooth® Low Energy Coded PHY.

The module has a low sleep current of 0.8 μA with RTC and 32KB RAM retention. Consistent with many customers’ 10 to 15 years or longer life cycle requirements.

BDE-MP2651R3A integrates all required system-level hardware components including clocks, passives, and PCB antenna into a QFM package for easy assembly and low-cost PCB design.

Key Features

 Wireless microcontroller
 Powerful 48-MHz Arm® Cortex®-M4 processor
 352KB flash program memory
 32KB of ultra-low leakage SRAM
 8KB of Cache SRAM (Alternatively available as general-purpose RAM)
 Programmable radio includes support for 2-(G)FSK, 4-(G)FSK, MSK, Bluetooth® 5.0 Low Energy, IEEE 802.15.4 PHY and MAC
 Supports over-the-air upgrade (OTA)
 Low power consumption
 MCU consumption:
 2.91 mA active mode, CoreMark®
 61 μA/MHz running CoreMark
 0.8 μA standby mode, RTC, 32KB RAM
 0.1 μA shutdown mode, wake-up on pin
 Radio Consumption:
 6.4 mA RX
 7.1 mA TX at 0 dBm
 9.5 mA TX at +5 dBm
 Wireless protocol support
 Zigbee®
 Bluetooth® 5.0 Low Energy
 SimpleLink™ TI 15.4-stack
 Proprietary systems
 High performance radio
 -103 dBm for Bluetooth® Low Energy 125-kbps
 Output power up to +5 dBm with temperature compensation
 Regulatory compliance (On-going)
 FCC
 IC
 CE-RED
 Bluetooth SIG
 MCU peripherals
 Digital peripherals can be routed to any GPIO
 Four 32-bit or eight 16-bit general-purpose timers
 12-bit ADC, 200 kSamples/s, 8 channels
 8-bit DAC
 Analog Comparator
 UART, SSI, I2C, I2S
 Real-time clock (RTC)
 Integrated temperature and battery monitor
 Security enablers
 AES 128-bit cryptographic accelerator
 True random number generator (TRNG)
 Additional cryptography drivers available in Software Development Kit (SDK)
 Operating range
 On-chip buck DC/DC converter
 1.8-V to 3.8-V single supply voltage
 -40 to +85°C
 -40 to +105°C (BDE-MP2651R3A-IN)
 Antenna: PCB antenna
 Package
 Dimension: 22.95 mm x 15 mm x 2.15 mm
 QFM-36 (31 GPIOs)
 RoHS-compliant package

Applications

 2400 to 2480 MHz ISM and SRD systems with down to 4 kHz of receive bandwidth
 Building automation
 Building security systems – motion detector, electronic smart lock, door and window sensor, garage door system, gateway
 HVAC – thermostat, wireless environmental sensor, HVAC system controller, gateway
 Fire safety system – smoke and heat detector, fire alarm control panel (FACP)
 Video surveillance – IP network camera
 Elevators and escalators – elevator main control panel for elevators and escalators
 Industrial transport – asset tracking
 Factory automation and control
 Medical
 Electronic point of sale (EPOS) – Electronic Shelf Label (ESL)
 Communication equipment
 Wired networking – wireless LAN or Wi-Fi access points, edge router , small business router
 Personal electronics
 Home theater & entertainment – smart speakers, smart display, set-top box
 Wearables (non-medical) – smart trackers, smart clothing

Downloads

Datasheet: BDE-MP2651R3A_Datasheet_V1.0.pdf
【Close】
Pre: BDE-MP2652R7A(Multi-Protocol Based on CC2652R7)
Next: BDE-MP2652P7(Multi-Protocol with PA Based on CC2652P7)